FMI VSGF36NRC - Manual (Page 18)

www.fmiproducts.com 121082-01K 18
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specifically
approved with this heater may
result in property damage or
personal injury.
CAUTION: Do not remove
the data plates attached to the
heater base assembly. The data
plates contain important safety
and warranty information.
It is very important to install these logs exactly
as instructed. Do not modify logs. Only use
logs supplied with heater.
1. Place bottom log in center of the base
assembly as shown in Figure 24.
2. Rest rear log in back corner sections of
base assembly as shown in Figure 24.
Make sure log is completely vertical and
not leaning in toward burner where the
flame will touch the log.
3. Position front right log against right side
of grate prongs (see Figure 24).
4. Position front left log against left side of
grate prongs (see Figure 24).
INSTALLATION
Continued
Figure 24 - Installing Bottom Logs
Figure 25 - Installing Top Logs
Rear Log
Grate
Prongs
Bottom
Log
Base Assembly
Front Right
Log
Front
Left Log
Middle Right Log
Middle Left Log
Bottom
Log
Pin on Front
Left Log
5. Place middle right log over front right and
bottom logs as shown in Figure 25. Be
sure hole in middle right log seats over
pin in bottom log.
6. Place middle left log over front left and
bottom logs as show in Figure 25. Be
sure hole in middle left log seats over pin
in front left log.
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.