Fisher DC-TS960WL - Manual (Page 19)

GB-6 [ENGLISH]
Reversing the positions of the speakers
It is possible to reverse the positions of front speakers and surround
speakers shown in the previous page.
In consideration of the connection of the mains lead etc., select a favorable
one from the two installation patterns.
Installation of the front speaker with mains lead at the right side
Installation of the surround speaker with mains lead at the right side
The other connections should be as shown in the previous page.
Changing the frequency setting
If noise (or skipping sound) is heard when using surround speaker in
wireless mode, change the setting of the CH SELECT switch on the back
of the front speaker with mains lead. It may improve the sounds.
Front speaker with mains lead
Front speaker
Red Violet Gray
Red
Violet Gray
Red
Surround speaker with mains lead Surround speaker
White
White
White
CH SELECT
1 (2,414 MHz)
2 (2,432 MHz)
3 (2,450 MHz)
4 (2,468 MHz)
About surround speaker connections
Because the surround speakers of this unit are of the wireless type, it is
not necessary to connect the assistant speaker lead under normal
conditions.
If noise is caused to the surround speaker when used in wireless mode,
change the setting of the CH SELECT switch on the back of the front
speaker with mains lead.
If noise is still caused, connect the surround speaker with mains lead to the
front speaker with mains lead using the supplied assistant speaker lead.
In this case, the audio signal is sent to the surround speaker through the
assistant speaker lead.