Furuno INMARSAT-C MOBILE EARTH STATION FELCOM 12 - Manual (Page 43)

2-5
23. Press [Enter] to open the selection window.
Setup
9. Configuration
System Setup
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
DTE1
OFF
DTE1 System Date & Time
Preferred NCS
MES Operation Mode
Active Port
Nav Port
Message Output Port
EGC Output Port
DTE1
DTE2
PC/DATA
AUTO
Figure 2-11 System setup menu, message output port
24. Select the DTE where you want to store receive messages.
DTE1: All receive messages are routed to the main DTE
(connected to DTE1 on the communication unit)
regardless of sub address.
DTE2: All receive messages are routed to the 2nd DTE
(connected to DTE2 on the communication unit)
regardless of sub address.
PC/DATA: All receive messages are routed to the PC/DATA
(connected to PC/DATA on the communication unit)
regardless of sub address (not used).
AUTO: Select to route messages with sub address 000 to
the main DTE, and messages with the sub address
of the 2nd DTE to the 2nd DTE. All other mes-
sages are routed to the main DTE.
Note: Do not select DTE2 or Auto when there is no DTE con-
nected to the DTE2 port; messages cannot be read from
the communications unit.
25. Press [Enter] to close the selection window.
26. Press [
/
] to advance the cursor to the EGC Output Port line.
27. Press [Enter] to open the selection window.
Setup
9. Configuration
System Setup
01:53 97-08-04 (YY-MM-DD)
IOR
INMARSAT-C
OFF
DTE1
DTE1 System Date & Time
Preferred NCS
MES Operation Mode
Nav Port
Active Port
Message Output Port
EGC Output Port
DTE1
DTE1+DTE2
Figure 2-12 System setup menu, EGC output port
28. Select the DTE where you want to store receive EGC messages;
DTE1, DTE2 or PC/DATA.
29. Press [Enter] to close the selection window.