Fujitsu Siemens Computers Loox T - Manual (Page 77)

Creating messages
Receiving e-mails and other data automatically in
real-time (e-mail push)
If you have a data connection to a mobile network provider (GPRS/UMTS) for your Pocket PC then
your e-mails, calendar data, contact data, tasks etc. can be delivered from the network to your
Pocket PC in real-time via e-mail push.
If your device is switched off (Standby mode) when new data are received via e-mail push then the
LED will start to flash.
The following conditions must be satisfied in order to use e-mail push:
•
The server must support e-mail push.
• Exchange Server 2003 Service Pack 2 is installed.
• Direct push has been set up by your administrator on your Pocket PC.
i
Please consult your administrator if you have any queries.
In general, e-mail push should already be activated on your device after being set up by the
administrator.
To deactivate e-mail push, you will need to deactivate the corresponding profile on your Pocket PC:
►
In the Today screen, press and hold the End key.
The profile list is displayed.
►
Select the profile Direct Push.
The profile is deactivated.
E-mail push is deactivated.
►
To reactivate e-mail push, select the profile Direct Push again.
The profile is activated.
i
Detailed information on adjusting the device behaviour when e-mail push is activated can
be found in "Configuring device behaviour when E-mail push is activated".
A26391-K182-Z120-1-7619, edition 1 67