Furuno FR-2105-B - Manual (Page 126)

-4.12-
You can show the external waypoint from a navaid by following steps.
1. Press [NAV MENU] and [2] to open WAYPOINT menu.
2. Press [7] to select WPT DATA.
3. If NAVAID is not in reverse video, press [7] again.
4. Press [2]. If ON is not in reverse video, press [2] again.
5. Press the ENTER key.
4.8 Navigation Lines
30 navigation lines may be entered, and each line may have up to 30 waypoints.
Entering New Navigation Line
1. Press [NAV MENU], [4], [5] and [2].
2. Enter navigation line number in two digits and press [ENTER].
3. Enter waypoint number in two digits and press [ENTER].
4. Repeat step 4 to continue entering waypoint numbers.
5. Press [NAV MENU] to register navigation line.
Adding Waypoint to Navigation Lines
To add waypoints to a navigation line;
1. Press [NAV MENU], [4] and [5].
2. Press [2]. Enter navigation line number and press [ENTER] , [CANCEL].
3. Press [8].
4. Enter “FROM” waypoint number to add and press [ENTER].
5. Enter waypoint number to add.
8 ADDING
WPT00 -> 00
9 ····
Newly added waypoint
"from" waypoint
6. Press [NAV MENU] to close the menu.
Removing Waypoints in Navigation Lines
1. Press [NAV MENU], [4] and [5].
2. Press [2] and enter navigation line number and press [ENTER], [CANCEL]
3. Press [9], enter waypoint number and press [ENTER].