Frymaster 8196428 - Manual (Page 15)

1-11
2. Disconnect the fryer from the electrical power supply and reposition it to gain access to both the
front and rear.
3. Disconnect the flexlines running to the oil-return manifold at the rear of the fryer as well as the
pump suction flexlines at the end of the filter pan connection (see photos below).
Disconnect flexlines indicated by the arrows.
4. Loosen the nut and bolt that secures the bridge to the oil-return manifold.
5. Remove the cover plate from the front of the motor and disconnect the motor wires.
6. Unplug the pump motor assembly 6-pin connector C-2 and, using a pin pusher, disconnect the
vent vacuum-breaker solenoid (pins 2 and 5) that is attached to the oil return manifold.
7. Remove the two nuts and bolts that secure the front of the bridge to the cross brace and carefully
slide the bridge rearward off the cross brace until its front end can be lowered to the floor. Undo
the single nut holding it in place in back. Be careful not to let the rear of the bridge slip off the
manifold at this point.
8. Get a good grip on the bridge, carefully pull it forward off the oil-return manifold, and lower the
entire assembly to the floor. Once on the floor, pull the assembly out the front of the fryer.
9. When required service has been completed, reverse Steps 6-
12 to reinstall the bridge.
NOTE: The black motor wires go on the top terminal, the
white on the bottom. The pump solenoid valve wires go in
positions 1 and 4 of the 6-pin connector C-2; the vent
vacuum-breaker solenoid valve wires go in positions 2 and 5;
the red/black heater tape wires go into position 3 and the
violet/white wires go into position 6 (see illustration on the
following page).
Rib marks position 1
4
1
5
2
Oil Return Solenoid, Vent Solenoid
and Heater Lead Positions
3
6