FUJITSU Solaris PCI GigabitEthernet 3.0 - Manual (Page 34)

3.3 Operation Mode Setup
Parameter Value Description
Off Auto-Negotiation is disabled. (Fixed mode)
Auto (default)
Connection speed of 1000, 100, or 10 Mbps is
set based on negotiation with the remote
device.
(This can only be set when
AutoNegotiation_A=On.)
1000 Connect at 1000Mbps.
100 Connect at 100Mbps.
LinkSpeed_A *2
10 Connect at 10Mbps.
Both (default)
Indicating that both Full-Duplex and
Half-Duplex are being supported.
(This can only be set when
AutoNegotiation_A=On.)
Half Half-Duplex operation is allowed.
DuplexCapabilities_A *2
Full Full-Duplex operation is allowed.
Auto (default)
Flow control is performed according to a setup
of partner equipment.
Rem
Only flow control from the remote machine is
allowed. Flow control to the remote machine
is not allowed.
LocSend
Only flow control from the main unit is
allowed. Flow control from the remote machine
is not allowed.
FlowControl_A *3
None Flow control is disabled.
Auto (default)
Master or Slave is set based on negotiation
with the remote device.
(This can only be set when AutoNegotiation_A=
On.)
Master Communication by Master.
Role_A *4
Slave Communication by Slave.
fjgi_mtu *5 1500 to 9000 MTU size is specified.
*1: When PW008GE5 or PW0G8GE2 is used, it is possible to set name="FJSV,pgtb". When PW008GE4
or PW0G8GE1 is used, it is possible to set name="FJSV,pgsb". It becomes the same meaning
as having specified name="fjgi" in both cases.
*2: Parameter is supported on 10/100/1000Base-T (PW008GE5, PW0G8GE2, SE0X7GD1X, PW008QG1,
SE0X7GQ1X) adapters and PRIMEPOWER250/450 secondary LAN port.
*3: Parameter is effective only when AutoNegotiation_A=On. When AutoNegotiation_A=Off, with
10/100/1000 Base-T, it becomes FlowControl_A=None. And with 1000 Base-SX, it becomes
FlowControl_A=Rem.
*4: Parameter is supported on 10/100/1000Base-T (PW008GE5, PW0G8GE2, SE0X7GD1X, PW008QG1,
SE0X7GQ1X) adapters and PRIMEPOWER250/450 secondary LAN port in 1000Mbps mode only.
*5: Parameter is supported only in Solaris 9 or later, and when the following patch for PRIMEPOWER
is applied.
In the case of Solaris 9 OS: 114994-13 or later
In the case of Solaris 10 OS: 120462-06 or later
[Parameter Setting]
The following shows how to set the parent and unit-address parameter in the fjgi.conf file.
● Find the fjgi device tree, device node and instance number in the /etc/path_to_inst
27