FUJITSU Solaris PCI GigabitEthernet 3.0 - Manual (Page 66)

Appendix A Messages
This chapter explains messages from the FUJITSU PCI GigabitEthernet driver
A.1 Console Messages
Console messages from the FUJITSU PCI GigabitEthernet driver are listed in Table A.1.1.
Table A.1.1 Console Messages of the FUJITSU PCI GigabitEthernet driver
No Message Cause Workaround
1 network connection down Link is down
Check the cable
connection and the
switch configuration.
Link has become up
[A]
1000: Transmitting and
receiving data at 1000Mbps
100: Transmitting and
receiving data at 100Mbps
10: Transmitting and
receiving data at 10Mbps
[B]
yes: Auto-Negotiation is on
no: Auto-Negotiation is off
[C]
full: Transmitting and
receiving data in full duplex
mode
half: Transmitting and
receiving data in half duplex
mode
2 network connection up using portA
speed: [A]
autonegotiation:[B]
duplex mode: [C]
flowctrl: [D]
(role: [E]) *1
[D]
symmetric: Send/accept
Flowcontrol request to/from
the remote system.
remote send: Does not send
Flowcontol request. Only
accept Flowcontrol request
from the remote system.
local send: Only send
Flowcontrol request. Does
not accept Flowcontrol
request from the remote
system.
none: Disabled
There is no problem.
59