FUJITSU Solaris PCI GigabitEthernet 3.0 User Manual
Page 68
A.1 Console Messages
No
Message
Cause
Workaround
13
Unable to map adapter registers.
Mapping of the adapter
registers failed.
14
ddi_get_iblock_cookie-ERROR
15
Unable to install interrupt routine.
The driver could not allocate
interrupt resources.
16
ddi_create_minor_node failed
Creation of a device file
failed.
17
ATTACH failed
The driver was not loaded to
the kernel successfully.
18
OPEN failed: ENOMEM
19
CLOSE: stream==NULL
The driver could not allocate
resources.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
20
bind to 802.2 failed
A different protocol is being
used.
Re-activate the
interface. If this
message is still
displayed, report to
your service provider.
21
Duplex are invalid !! Please change
the partner's duplex Full.
With
PW008GE4/PW0G8GE1/SE0X7GD2X
, the other end is using half
duplex mode.
With
PW008GE4/PW0G8GE1/SE0X7
GD2X, only full duplex is
available. Change the
duplex mode of the other
end to Full.
22
DL_DETACH_REQ: No board ptr
The adapter was not
recognized.
Check the mounting
status of the adapter.
23
fjgi_param_register error
The driver could not allocate
resources for the ndd
parameter.
24
fjgi_board_alloc_mem failed !!
The driver could not allocate
resources.
25
Error filling TX ring
The driver could not allocate
transmit resources.
26
status block can't alloced!
27
status block can't alloced handle!
28
status block can't bind handle!
The driver could not allocate
status information
resources.
29
fjgi_board_init_mem: Failed to
dma_alloc !!
The driver could not allocate
DMA resources.
30
statistic block can't alloced!
31
hwmib block can't alloced handle!
32
hwmib block can't bind handle!
The driver could not allocate
statistic information
resources.
33
fjgi_board_init_mem: Failed to dma
alloc2!!
The driver could not allocate
DMA resources.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
34
Illegal value for LinkSpeed_A
The value of LinkSpeed_A in
the configuration file is
incorrect.
Set the correct value for
LinkSpeed_A.
35
fjgi_hw_init:Step 22 failed
36
fjgi_hw_init:Step 23 failed
37
fjgi_hw_init:Step 43 failed
An error occurred during
initialization of the
adapter.
A hardware failure
occurred. Please contact
your service provider.
38
Illegal combination of values AutoNeg
and Speed
Auto speed can not be used in
fixed mode.
Set a value other than
Auto for LinkSpeed_A.
61