FUJITSU Solaris PCI GigabitEthernet 3.0 - Manual (Page 67)

Appendix A Messages
No Message Cause Workaround
[E]
Master: Communicating as
Master
Slave: Communicating as
Slave
3 Illegal value for [ParameterName].
An error was found with a
parameter defined in the
fjgi.conf file.
Check whether the value
is set correctly in the
file.
4 soft state alloc failed.
Driver internal resources
cannot be obtained.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
5
Allocation of descriptor memory
failed
The driver could not allocate
internal resources for DMA.
6 fail to ddi_dma_bind_handle
The driver could not allocate
DMA resources.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
7 fail to FragCount
A error was found in message
fragmentation.
Re-activate the
interface. If this
message is still
displayed, report to
your service provider.
8 Could not allocate DMA handle
The driver could not allocate
DMA resources.
9 Could not bind descriptor memory
The driver could not allocate
DMA resources.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
10 Multiple fragments in descriptor area
A error was found in message
fragmentation.
Re-activate the
interface. If this
message is still
displayed, report to
your service provider.
11 fjgiallocthings failed
The driver could not allocate
DMA resources.
Installed physical
memory may be
insufficient. If this is
not the cause, report
this error to your
service provider.
12 pci_config_setup_failed
The driver could not allocate
sufficient PCI configuration
space.
Installed physical
memory may be
insufficient or hardware
has failed. Report this
error to your service
provider.
60