FUJITSU Solaris PCI GigabitEthernet 3.0 - Manual (Page 51)

Chapter 3 Setting Configuration Information
ok boot /pci@1f,4000/FJSV,pgtb@5
9. Install the Solaris OS.
10. After Solaris OS installation, check whether the FUJITSU PCI GigabitEthernet
software has already been installed using the following command.
# pkginfo | grep FJSVgid
example) # pkginfo | grep FJSVgid
system FJSVgid Fujitsu Gigabit Interface Adapter
system FJSVgidx Fujitsu Gigabit Interface Adapter (64-bit)
If the software has not been installed, install the FUJITSU PCI GigabitEthernet
software from the CD-ROM that came with the adapter. Refer to the "
Installation Guide
FUJITSU PCI GigabitEthernet 3.0 Update1 " for more information about installation.
● When you install Solaris 2.6 OS via a network, please be sure to set the value of
the "local-mac-address?" parameter of a client system as "false".
44