Furuno NAVNET GD-1920C - Manual (Page 109)

3. PLOTTER OPERATION
3-44
Restarting navigation
When you steer to avoid an obstacle or the vessel drifts, you may go off your intended
course, as in Line 1 in the figure below. Also, if you don’t need to return to the original
course, you can go directly to the next waypoint, as in Line 2 in the figure below. In these
cases, use the restart navigation function to restart navigation.
Original course
Obstacle
Line 1
Line 2
Example of when to restart navigation
1. Press the MENU key to open the menu.
2. Press the WAYPOINTS/ROUTES soft key.
3. Press the LOG soft key.
Estimated Time of Arrival at destination
Passed waypoint (gray characters)
TO Waypoint (WPT name in reverse video)
▲
LOG
RE-
START
STOP
RVRSE
SPEED
COORD
TYPE
ETA 23:59 30. APR
02
90.0 °
2.86nm
322.6
°
3.08nm
75.2
°
4.99nm
152.5 °
19.87nm
LEG 01 48 ° 18.290'N
123 ° 14.286'W 007WPT
48
°
17.341'N
123 ° 10.232'W 005WPT
03 48 ° 20.261'N
123
°
11.658'W 003WPT
04 48
°
19.862'N
123 ° 04.190'W 006WPT
02
Replaces triangle
when selecting a
route leg.
Replaced by
"FOLLOW LEG"
when selecting
a route leg.
Log display
4. Use the Trackball to select a waypoint or a route leg. When a route leg is selected the
single arrow cursor is replaced by double arrows.
5. Press the RESTART soft key or FOLLOW LEG soft key in case of route leg.
RESTART: Line2 in the figure above
FOLLOW LEG: Line 1 in the figure above
6. Press the MENU key to close the menu.