FARGO electronic HDP5000 - Manual (Page 199)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4) 7-4
Installing the Card Lamination Module
Introduction
The following guide provides a step-by-step installation procedure for the HDP5000
Lamination Module and Printer Driver Accessory. Refer to the HDP5000 High Definition Card
Printer/Encoder User Guide for details on operating your new card Lamination Module.
The time required for each installation is provided below:
• Lamination Module Installation (time required): This hardware installation process will
require approximately 10 to 15 minutes.
• Driver Software Installation (time required): This software installation process will
require approximately 2 to 6 minutes (depending on the speed of your PC).
The System Requirements are as follows:
• IBM-PC or compatible, Windows® 2K/XP/., Pentium® class 500MHz computer with
256MB of RAM or higher, 500MB free hard disk space or higher and USB 2.0