FARGO electronic HDP5000 - Manual (Page 8)

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP5000 High Definition Card Printer/Encoder User Guide (Rev. 1.4) viii
Print Tension Settings _______________________________________________________________ 9-25
Using the Ribbon Print Takeup Tension Option_________________________________________ 9-25
Using the Film Print Takeup Tension Option___________________________________________ 9-25
Using the Ribbon Print Supply Tension Option _________________________________________ 9-26
Transfer Tension Settings ____________________________________________________________ 9-27
Using the Film Supply Transfer Tension Option ________________________________________ 9-27
Using the Film Takeup Transfer Tension Option ________________________________________ 9-27
Using the Resin Heat Adjust Option__________________________________________________ 9-28
Using the Sleep Time Option _______________________________________________________ 9-28
Using the Standby Time Option _____________________________________________________ 9-28
Using the Blush Point Option _______________________________________________________ 9-28
Using the LCD Contrast Option _____________________________________________________ 9-29
Using the Cleaning rate Option _____________________________________________________ 9-30
Using the EAT Disable Option______________________________________________________ 9-30
Using the Film Print Cooling Level Option ____________________________________________ 9-30
Using the Film Transfer Cooling Level Option _________________________________________ 9-30
Using the Enable Ribbon Wrinkle Compensation Option _________________________________ 9-30
Using the Lamination Top of Form Option ____________________________________________ 9-30
Using the Lamination End of Form Option ____________________________________________ 9-30
Using the Lamination Bottom Takeup Option __________________________________________ 9-30
Using the Lamination Top Takeup Option _____________________________________________ 9-30
Using the Lamination Card Backup Option ____________________________________________ 9-31
Using the lamination Card Length Option _____________________________________________ 9-31
Reviewing the No Printer Connected error message _____________________________________ 9-31
Reviewing the Value outside the Range error message ___________________________________ 9-31
Section 10: Cleaning ______________________________________________________ 10-1
Using the Required Supplies __________________________________________________________ 10-1
Safety Messages (review carefully)_____________________________________________________ 10-2
Accessing the Clean Printer tab________________________________________________________ 10-3
Cleaning the Printer Platen Roller and Card Feed Rollers _________________________________ 10-3
Cleaning Procedures ________________________________________________________________ 10-5
Cleaning inside the Printer _________________________________________________________ 10-5
Cleaning outside the Printer ________________________________________________________ 10-5
Cleaning the Printhead ____________________________________________________________ 10-6
Replacing the Card Cleaning Roller __________________________________________________ 10-7
Cleaning the Magnetic Encoder _____________________________________________________ 10-8
Section 11: Fargo Workbench Printer Utility __________________________________ 11-1
Reviewing the Card tab and Diagnostic button _________________________________________ 11-1
Section 12: Fluorescent Panel Usage_________________________________________ 12-1
Configuring Fluorescent Data (F-Panel for YMCFK Ribbon) using the Workbench ____________ 12-2
Configuring Fluorescent Data (F-Panel for YMCFK Ribbon) using the Application ___________ 12-12
Section 13: Packing the Card Printer ________________________________________ 13-1
Section 14: Firmware Updates ______________________________________________ 14-1
Performing the Firmware Updates ___________________________________________________ 14-1
Section 15: Fargo Technical Support ________________________________________ 15-1
Contacting Fargo Technical Support____________________________________________________ 15-1
Reading the Serial Numbers on a Fargo Printer ___________________________________________ 15-2
Finding out when a Fargo Card Printer was manufactured ________________________________ 15-2
Reviewing Example No. 1: Serial Number A1280224 ___________________________________ 15-2
Section 16: Reviewing Spare Parts Lists ______________________________________ 16-1
Reviewing Spare Parts List for HDP5000 and HDP5000-LC ______________________________ 16-1