Furuno FAR-2107(-BB) - Manual (Page 129)

1. RADAR OPERATION
1-107
FRONT HALF
LENGTH
REAR HALF
LENGTH
NET WIDTH
a
b
[ CURSOR SHAPE]
1 BACK
2 CURSOR
OFF/ON
3 FRONT HALF LENGTH
0.0m
4 REAR HALF LENGTH
0.0m
5 NET WIDTH
0.0m
6 ROTATE STEP
360°/32 POINTS
WARP LENGTH
0.0m
5. Select 2 [CURSOR] then push the left button.
6. Select ON then push the left button to enable the net cursor. EBL2 is then
automatically turned on.
7. Push the right button four times to close the menu.
1.55.2 Setting net cursor dimensions, adjusting net cursor
orientation
1. Left-click the MENU box.
2. Select 2 [MARK] then push the
left button.
3. Select 9 [EBL, VRM, CURSOR
SET] then push the left button.
4. Select 8 [CURSOR SHAPE] then
push the left button.
5. Set net cursor dimensions as
follows, referring to the illustration
at right.
a) Select FRONT HALF LENGTH
then push the left button.
b) Spin the scrollwheel to set front half length (0-3000 m) then push the left
button.
c) Set REAR HALF LENGTH and NET WIDTH similarly.
d) Warp length (a+b in the illustration at right) is indicated at the bottom of the
menu. The net cursor is placed at the screen center, with its top and bottom
points bisected by EBL2. To adjust the position of the net cursor, go to step 6.
Otherwise, go to step 9.
6. Select 6 ROTATE STEP then push the left button.
7. Select 360
° or 32 POINTS as appropriate then push the left button. These
figures determine how finely to rotate the EBL2 when adjusting the
orientation of the net cursor. Select 360
° for fine rotation or 32 POINTS for
coarse rotation.
8. Use the rotary encoder for the EBL to adjust the orientation of the net cursor.