FMI VM36E(B - Manual (Page 14)

www.fmiproducts.com 108796-01U 14
0.5"
0.5"
Figure 22 - Pan and Ember Material
Clearances
Grate
Burner Pan
Pan and Ember
Material
INstallatIoN
Continued
LOG PLACEMENT FOR MODELS
M36E, M36EP, VME36 AND VM36EP
1. Place small front right log (log 1) on right
front of grate as shown in Figure 23.
2. Place large back log (log 2) onto grate
making sure notches rest over grate as
shown in Figure 23.
3. Place log 3 into notch on log 2, resting
front end on top of log 1 (see Figure 24).
4. Place upper end of log 4 into notch on log
2 as shown in Figure 24. Rest lower end
of log 4 onto middle grate finger as shown
in Figure 25.
5. Place upper end of log 5 into notch on left
of log 2 (see Figure 25). Rest lower end
of log 5 on grate as shown in Figure 26.
6. Insert lower end of log 6 between first
two grate fingers as shown in Figure
26 and position upper end of log 6 into
notched area on front of log 2 as shown
in Figure 26.
As an option to enhance the look of the hearth,
you may place lava rock provided around front
and sides of burner.
NOTICE: Do not put lava rock
inside the burner pan or around
the air mixer fitting. Placing lava
rock inside the burner pan or
blocking the openings of the pro-
pane/LP air mixer could cause
performance problems.
Figure 23 - Installing Logs 1 and 2
Log 1
Log 2
Notch
Figure 24 - Installing Logs 3 and 4
Log 3
Log 4
Log 2
Log 1
Notches
Figure 25 - Installing Logs 5 and 6
Log 5
Log 6
Log 4
Notch
Notch
Figure 26 - Logs Installed for M36, M36P,
VM36 and VM36P Models