FMI VM36E(B - Manual (Page 15)

www.fmiproducts.com 108796-01UT 15
INstallatIoN
Continued
LOG PLACEMENT FOR MODELS
M42E, M42EP, VME42 AND VM42EP
1. Place large back log (log 1) onto grate
making sure notches rest over grate (see
Figure 27).
2. Insert lower end of log 2A between first
two grate fingers and position upper end
into notch on front of log 1. See Figure 27.
Place log 2B on front right side of grate as
shown in Figure 27.
3. Place log 3 into notch on top left of log 1,
resting lower end on left two grate fingers
(see Figure 28).
4. Place upper end of log 4 into notch on
log 1 as shown in Figure 28. Rest lower
end of log 4 on the middle grate finger as
shown in Figure 29.
5. Place upper end of log 5 into notch on top
inner right of log 1 (see Figure 29). Rest
lower end of log 5 on middle grate finger
as shown in Figure 30.
6. Place log 6 into notch on top right of log
1 (see Figure 29). Rest lower end of log
6 on top of log 2B (see Figure 30).
As an option to enhance the look of the hearth,
you may place lava rock provided around front
and sides of burner pan.
NOTICE: Do not put lava rock
inside the burner pan or around
the air mixer fitting. Placing lava
rock inside the burner pan or
blocking the openings of the pro-
pane/LP air mixer could cause
performance problems.
Figure 27 - Installing Logs 1, 2A and 2B
Log 2A
Log 2B
Log 1
Notch
Figure 28 - Installing Logs 3 and 4
Log 4
Log 3
Log 1
Notches
Figure 29 - Installing Logs 5 and 6
Figure 30 - Logs Installed for M42E,
M42EP, VM42E and VM42EP Models
Log 6 Log 5
Notch
Log 1
Log 2B