FUJITSU SRS-1050 - Manual (Page 100)

Chapter 4 ( SRS -1050 Data Operation
Page 4-1
CHAPTER 4
DATA OPERATION
The SRS-1050 Digital Set is
available in a voice/data model
that allows you to use the set for
data applications. Please refer to
the Fujitsu ISDN Data User's
Guide for information on how to
set up and configure the Terminal
Adapter for proper operation.
UNA DATA CLEAR REG
1 2 3 4
5:20 PM Tuesday January 4
Key Menu
Standard Softkey Layout
(The DATA softkey label appears
only if you have a data terminal.)
Note: Softkey 1 also serves as
the ENTER key (for entering
information as indicated in
this User Guide).
USING THE DATA TERMINAL
ADAPTER
This chapter describes three ways
to make a data call using the
integrated Terminal Adapter (TA)
in your Digital Set.
•
Using the DATA softkey
(second button from the left
under the display)
•
Using AT commands at your
terminal
•
Using the X.28 commands at
your terminal
Following these procedures is a
section on placing a call to a
leased network number.
There are three LEDs below the
multifunction buttons of the SRS-
1050. DTR (Data Terminal Ready)
must be steady green to establish
a connection.
Transmitting data from your
terminal causes the TXD
(Transmit Data) LED to flash, and
receiving data causes the RXD
(Receive Data) LED to flash.
MAKING AND TERMINATING
A DATA CALL
You can start or end a data call
either manually or by using
commands at your terminal, as
described in the following
sections.
Using the DATA Key
To make a data call using the
digital set DATA key, follow
these steps:
1. Press DATA (softkey 2).