FUJITSU SRS-1050 - Manual (Page 120)

SRS -1050 Testing ( Appendix C
Page C-2
•
Press 5 to start the Program
and Loop switch test (with
optional data terminal adapter
only).
These tests are described in the
sections below. Tests 1, 2, 3, and
5 can be started and interrupted at
will to change the test under way,
but test 4 cannot be interrupted
by pressing any key.
Key Test
Pressing any button other than 1
through 5 sounds its associated
confirmation or DTMF tone, turns
its LED red (if it has one), and
displays the following information
on the LCD:
For the keys:
Soft keys
Key Menu Key
Multifunction buttons
Fixed function buttons
DTMF keypad keys
This information is
displayed:
SOFTWARE Key X
Key Menu
MULTIASSIGN KEY nn
FUNCTION KEY 1
FUNCTION KEY 2
FUNCTION KEY 3
FUNCTION KEY 4
FUNCTION KEY 5
FUNCTION KEY 6
TEN KEY X
With the range and
meaning shown here:
X=1:SOFT1 2:SOFT2
3:SOFT3 4:SOFT4
Key Menu Key
nn: 1 to 18 (key no.)
DROP
TRANSFER
HOLD
CONFERENCE
REDIAL
SPEAKER
X=(5), 6, 7, 8, 9, 0, #,
and *
(DTMF keys 1, 2, 3, 4, and 5 (with data terminal adapter installed) are
reserved for test selection and not displayed on the LCD.)
Tone Test
When you press 1 on the DTMF
keypad, the speaker sounds a
Ringer Tone. If you pick up the
handset, the ringing stops and a
Busy tone is sent to the handset.
The LCD shows the following
display:
SELF TEST (TONE)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . .