Friedrich 920-087-09 (12/10) - Manual (Page 15)

15
3. Route.the.cut.ends.of.harness.through.the.conduit.connector.
assembly.and.flex.conduit.sleeve...Be.sure.to.use.the.supplied.
conduit.bushing.to.prevent.damage.to.the.cord.by.the.conduit..
.
The.cord.should.pass.through.the.Locknut,.Spacer,.Chassis.
Junction.Box,.Conduit.Connector,.Bushing,.then.the.Conduit.
Sleeve...See.Figure.17.
4. Route.the.cut.ends.of.the.power.cord.through.the.elbow.connector.
at.the.other.end.of.the.conduit...Tighten.screws.on.elbow.connector.
to.secure.conduit.sleeve.
5. Fasten.and.secure.the.elbow.connector.to.the.wall.junction.box.
cover.with.locknut...Place.and.mount.the.wall.junction.box.with.
the.four.wall.mounting.screws.making.sure.to.pass.the.wall.lines.
through.the.junction.box...Connect.and.join.all.wall.lines.with.the.
stripped.ends.using.wire.nuts...Tighten.both.screws.of.the.wall.
junction.box.cover.to.junction.box.
6. Follow.steps.4-6.on.page.19.and.refer.to.Figure.27.
Figure 15 Figure 16
Figure 17
FRP032
4.0 IN.
18.0 IN.
TRIM HARNESS
TO LENGTH
STRIP WIRE ENDS (0.5 IN.)
TO WALL JUNCTION
TO CHASSIS JUNCTION
EXPOSE
WIRES
(1.0 IN.)
FRP033
GROUND
SCREW
GROUND
WIRE
HARNESS
JUNCTION
BOX
WALL CONNECTION
JUNCTION
BOX COVER
COVER
SCREWS
STRAIGHT
CONNECTOR
FRP034
LOCKNUT
SPACER
SPACER
BUSHING
LEADING SIDE FOR
WIRE HARNESS INSERTION
EXITING SIDE FOR
WIRE HARNESS
CHASSIS
JUNCTION
BOX
CONDUIT
CONNECTOR
CONDUIT
SLEEVE