Friedrich 920-087-09 (12/10) - Manual (Page 6)

6
Wall Sleeve Installation Instructions (PDXWS)
NOTE:. Insure.that.the.unit.is.only.installed.in.a.wall.structurally.adequate.to.support.the.unit.including.the.sleeve,.chassis.and.accessories...If.the.sleeve.
projects.more.than.8".into.the.room,.a.subbase.or.other.means.of.support.MUST.be.used...Please.read.these.instructions.completely.before.
attempting.installation.
For Deep Wall Installation (Greater than 13 1/4")
See Page 9
The.following.instructions.apply.ONLY.to.walls.less.than.13.¼".in.depth..
1. The.PXDR10.Drain.Kit.(optional.for.new.construction).see.page.10.
if.applicable,.must.be.installed.before.the.wall.sleeve.is.installed.
into.the.wall.
2. The.External.Drain.(for.new.construction.or.unit.replacement).see.
page.11,.if.applicable,.must.be.installed.before.the.wall.sleeve.is.
installed.into.the.wall.
3. From.inside.the.building,.position.the.wall.sleeve.in.the.opening.and.
push.it.into.the.wall.until..it.protrudes.at.least.¼”.on.the.outside...Do.
not.allow.sleeve.to.be.pulled...(See.Figure.11,.Page.10).
4. Position.the.wall.sleeve.with.a.slight.tilt.towards.the.outside.to.
facilitate.condensate.drainage...It.should.be.level.side-to-side.and.
the.front.should.be.¼.bubble.higher.than.the.back.
Figure 3
Typical Wall Sleeve Installation
NOTICE
DO NOT allow any pitch toward the inside.
Flashing on all 4 sides of the opening is recommended.
Potential property damage can occur if instructions are
not followed.
WARNING
Falling Object Hazard
Not following Installation Instructions for
mounting your air conditioner can result
in property damage, injury, or death.
FRP008
20 "
MAX.
16-¼ "
42-¼ "
MIN. LINTEL TO SUPPORT
MASONRY WALLS
ELECTRICAL
RECEPTACLE
ELECTRICAL
RECEPTACLE
WALL OPENING
WALL SLEEVE
INSULATION
INSULATION
SMOOTH SIDE OF SCREW
CLIP FACING INTO ROOM
NOTE: All 230/208V units are manufactured with a 72” power cord and all 265V units with a 20” power cord.
60 "
MAX.
13-¾ "