General specifications installation checklist, Model number, Typical unit components and dimensions – Friedrich 920-087-09 (12/10) User Manual

Page 4

Advertising
background image

4

General Specifications

Installation Checklist

q

. Inspect.all.components.and.accessories.for.damage.before.and.after.

installation.

q

. Remove.the.cardboard.wall.sleeve.support.and.grill.weatherboard.

q

. Check.for.proper.wall.sleeve.installation.in.accordance.with.the.wall.

sleeve.installation.instructions.

q

. Check.for.a.subbase.kit.or.other.means.of.structural.support.which.

is.required.for.ALL.installations.projecting.more.than.8".into.room.

q

. Install. the. recommended. Condensate. Drain. Kits. for. complete.

condensate.removal.

q

. Ensure.that.the.chassis.is.installed.in.a.16".high.x.42”.wide.wall.sleeve.

that.is.no.deeper.than.13.¾"...A.baffle.kit.is.required.if.the.sleeve.

exceeds.that.depth.

q

. Ensure.that.chassis.and.chassis.front.cover.are.installed.and.secured.

properly.

q

. Ensure.that.drapes,.bed,.bedspread,.furniture,.etc...DO.NOT.block.

either.return.or.discharge.air.grilles.

q

. Inspect.the.condenser.air.inlet.and.outlet.for.any.obstructions.

(shrubbery,.etc.)

q

. Ensure.that.'reset'.button.is.pressed.on.LCD.device.(only.on.cord.

connected.models).

MODEL NUMBER

07 = 7,000 Btuh

09 = 9,000 Btuh

Nominal Capacity

12 = 12,000 Btuh

15 = 15,000 Btuh

Series

PD = Friedrich Digital PTAC

System

X = Accessory

E = Cooling with or without electric heat

H = Heat Pump with Auxiliary Heat

Voltage

K = 230/208V - 1 Ph. - 60 Hz.

R = 265V - 1 Ph. - 60 Hz.

Nominal Heater Size (230V or 265V)

0 = No Heater*

2 = 2.0 KW 3 = 3.0 KW 5 = 5.0 KW**

*

**

No Heater only available on 230V PDE models

5.0 kw only available on 9000, 12000 and 15000 BTU models

Chassis

S = Standard

Design Series

Note: All PTAC models with a C design series or

later come standard with Diamonblue seacoast

protection and digital controls.

Engineering Digit

PDXWS Wall Sleeve Dimensions:

16" H x 42" W x 13-¾" D

Front Cover Dimensions:

16" H x 42" W x 7-¾" D

Cut-Out Dimensions:

16-¼" x 42-¼"

Typical Unit Components and Dimensions

FILTERS

RETURN AIR GRILLE

FRONT COVER

CHASSIS

OUTDOOR GRILLE

WALL SLEEVE

DISCHARGE

GRILLE

Advertising