Fujitsu Siemens Computers Pocket LOOX 600 - Manual (Page 25)

Switching Pocket PC off and on Operating Pocket LOOX 600
A26391-K120-Z120-1-7619 17
Switching on with FSC Speed button
Ê Press the FSC Speed button (21) to switch on the Pocket PC.
The FSC SpeedMenu opens.
Please refer to section "FSC SpeedMenu – Operating Pocket LOOX 600 quickly with one hand" for
a description of operating the
FSC SpeedMenu .
Switching on with application buttons
You can also switch on your Pocket LOOX 600 by briefly pressing the applications buttons (14, 16,
18, 19). The applications assigned to the respective button appears on the screen. The applications
Tasks , Today , Contacts and Calendar are preset. However, you can change the applications to be
called up at any time according to your needs (see the chapter "Configuring Pocket LOOX 600“) so
that your preferred program opens immediately at the press of a button.
Switching on and off with soft reset (warm boot)
After certain applications or the installation of new programs, it may be necessary to restart the
Pocket PC with the soft reset.
! Data not yet saved in a file will be lost during this procedure. On the other hand, data in
the RAM memory are retained.
Ê End all applications before you carry out a soft reset.
Please note that data that have not yet been save in a file will be lost during this procedure.
Therefore, be sure not to conduct the soft reset until after exiting the running applications. On the
other hand, data in the RAM memory are retained.
1
1 = Soft reset (warm start)
Ê Take the stylus, insert it in the opening (1) and press briefly.
The warm boot is carried out. The application you have just been working in appears on the display
of your Pocket PC.