Fujitsu Siemens Computers Pocket LOOX 600 - Manual (Page 66)

Troubleshooting and tips
58 A26391-K120-Z120-1-7619
Ê Slide the cover closed again (3).
! If the device is switched off with the General Reset switch, the battery is switched off so
that the RAM contents are lost. This means you loose all data (documents, additionally
installed programs, personal settings) that you haven't saved elsewhere.
Therefore, remember to make a regular data backup with synchronisation (see the
chapter "Synchronising data with ActiveSync") or on corresponding memory cards
(available as an accessory). The program
LX Backup is provided on your Pocket LOOX
600 for completely backing up the RAM memory.
The battery is dead
Ê Connect the power adapter to the Pocket PC to charge the battery.
Or
Ê Connect the power adapter to the cradle and place the Pocket PC in the cradle for charging.
The battery discharges too quickly
The battery is either too hot or too cold.
Ê Bring the Pocket PC up / down to a normal temperature again.
If the operating time of the battery mode is extremely short, the battery is probably old and should
be replaced by service technicians. Contact our Hotline, which will forward you to the Service
Department.
The Suspend button does not respond properly
You have pressed the Suspend button too long to switch the Pocket PC on or off.
Ê Briefly press the Suspend button until the Pocket PC switches on or off.
No sound or minimal volume
Check whether the volume is set correctly.
Ê Touch the loudspeaker symbol in the navigation bar and set the volume with the slide control.
Make sure that the sound is switched on (marking in
On selection box).
or
Ê Touch Start.
Ê Select the Settings entry in the menu.
Ê Select the Personal tab.
Ê Touch the Sounds & Messages symbol.
Ê Set the desired volume with the slide control.
Ê Touch OK (navigation bar) to confirm your setting.