Frymaster CF SERIES MJCFEC - Manual (Page 21)

CF SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
3-2
ACCESSING THE PILOT
The pilot is mounted on the left side of the
burner manifold and is accessed through an
opening in the front frypot insulation. Swing the
round cover open and insert a long match or
taper through the hole (see photo) when lighting
the pilot.
LIGHTING THE PILOT ON NON-CE FRYERS
1. Ensure power to the unit is OFF, and then turn the gas valve knob to the OFF position. Wait at
least 5 minutes, and then rotate the gas valve knob to the PILOT position (see Figure 1).
Lighting the Pilot
OF
F
ON
PILOT
OF
F
ON
PILOT
Figure 1 Figure 2
2. Push the knob in and light the pilot. (If the fryer is equipped with a piezo ignitor, repeatedly
press the piezo ignitor button while depressing the gas valve knob until the pilot lights.)
Continue to hold the knob in for about 60 seconds after the flame appears on the pilot. Release
the knob. The pilot should remain lit.
CAUTION
If the pilot fails to remain lit, turn the gas valve knob to the OFF position and wait at
least five minutes before attempting to re-light.
3. With the pilot lit, push down and slowly turn the knob to the ON position (Figure 2).
Insert match or taper through
this hole to light pilot.