Follett Symphony 50HI400A 23 - Manual (Page 8)

8 25CI400A/W • 25HI400A • 50CI400A/W • 50HI400A
Fig. 9
9.1
9.3
9.2
9.4
1. Using Fig. 8 as a guide, locate wall bracket
mounting position relative to wall studs.
2. Install the supplied wall bracket with six 3/8"
diameter fasteners (Fig. 9.1).
Note: Three holes are available at each fastening
site to allow capture of studs or supports within the
wall.
2. Locate and cut utility hole in wall using Fig. 8
dimensions (9.2).
3. Rough in utilities. Wall mount bracket dimensions
(Fig. 8) can be used as a template.
Water: 1/2" FNPT
Drain: 3/4" FNPT
4. Lift dispenser onto wall bracket positioning unit so
that hook on back of dispenser is captured by wall
bracket support angle (Fig. 9.3).
5. Install two 1/4" X 20 screws through bottom of wall
bracket into bottom of dispenser to secure dispenser
to wall bracket (Fig. 9.4).
6. Install supplied 1/2" MPT X 3/8" push-in adapter
onto 1/2" FNPT water supply.
Installing wall mount dispensers
WARNING
• Wall mount dispensers are intended to be mounted above a
sink, eliminating the need for a drain pan.
• Before beginning installation verify that the sink size and
location meet the requirements shown in Fig. 7.
• If requirements are not met, a drain pan must be used to
prevent ice and water from falling on counter or floor.
• FAILURE TO TAKE THESE PRECAUTIONS COULD RESULT IN
SLIPS AND FALLS ON WET FLOORS
Fig. 7
Minimum sink requirements (without drain pan)
17"
(432mm)
24.5"
(623mm)
Side View
14.25"
(362mm)
18"
(458mm)
23"
(585mm) min.
50HI
58.5"
(1486mm)
25HI
54.5"
(1385mm)
Front View
Minimum Sink Requirements
(shown without drain pan)
21.5"
(547mm)
Front View
21.5"
(547mm)
23"
(585mm) min.
Sink centered
below dispenser
14.25"
(362mm) min.
Sink centered
below chutes
Fig. 8
Wall bracket location guide
.75"
(20mm)
50HI400A
15" (381mm)
25HI400A
13" (330mm)
50HI400A
21" (483mm)
25HI400A
19" (483mm)
16.00"
(406 mm)
0.438" (11mm)
clearance
6"
(153mm)
Wall stud Wall stud
Wall stud
Top view
Front view
Utility
cut-out
3.4"
(87mm)
4.12"
(105mm)
7"
(178mm)
1"
(26mm)
2.44"
(62mm)
3.50"
(89mm)
1"
(26mm)
(anchor
points)