Force10 Networks PSeries 100-00055-01 - Manual (Page 111)

P-Series Installation and Operation Guide, version 2.3.1.2 111
Example Figure 77
[root@localhost SW]# pnic start
No card number specified. Assuming card 0
Interface pnic0 is down
Loading pass/block settings ... Done.
Loading dynamic rules ... Done.
***************************************
Interface pnic0 is up
MTU set to 9264 bytes
***************************************
Version : P_MAIN2.2.0.058
[root@localhost SW]#
pnic start Command Example
Related
Commands
pnic stop
Turn off capture and disable the network interface.
Syntax
pnic stop [number]
Enable the network interface using the command pnic start .
Parameters
Command
History
Example Figure 78
[root@localhost SW]# pnic stop
No card number specified. Assuming card 0
Interface pnic0 is down
[root@localhost SW]#
pnic stop Command Example
Related
Commands
Usage
Information
This command disables the pnic software interface and disables capturin to the CPU, but the
card still forwards/blocks traffic on the wire.
pnic stop Disable the network interface.
number
Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.0.0.1 Introduced
pnic start Enable the network interface.