Force10 Networks PSeries 100-00055-01 - Manual (Page 80)

80 Appendix A
• pnic showconf on page 108
• pnic show-firmwares on page 108
• pnic showtech on page 109
• pnic start on page 110
• pnic stop on page 111
• pnic temp-mem-disable on page 112
• pnic temp-mem-enable on page 112
• pnic updatemacvalue on page 113
• pnic vlan-remove-disable on page 114
• pnic vlan-remove-enable on page 114
• pnic web-gui-start on page 115
• pnic web-gui-stop on page 116
Note: The P10 does not support multiple network interface cards. Therefore, the only
valid entry for the
number variable is 0.
Card 0 and Channel 0 are assumed for all commands if the
card and number options
are not specified.
pnic aggregate-mode-disable
Receive client-to-server and server-to-client traffic on different ports.
Syntax pnic aggregate-mode-disable [ number ]
Enable aggregate mode using the command pnic aggregate-mode-enable .
Parameters
Command
History
Example Figure 40 pnic aggregate-mode-disable Command Example
[root@localhost SW]# pnic aggregate-mode-disable
No card number specified. Assuming card 0
*** Aggregate mode disabling on card:0 successful.
[root@localhost SW]#
number
(OPTIONAL) Enter the number of the network interface card.
Range: 0-5
Default: 0
Version 2.3.0.0 Introduced