Force10 Networks PSeries 100-00055-01 - Manual (Page 35)

P-Series Installation and Operation Guide, version 2.3.1.2 35
You can manage and monitor the P-Series on the web using the Force10 Networks P-Series Node Manager.
Launching the P-Series Node Manager
Note: The Web-based GUI is best viewed with a minimum screen resolution of 1280x800. You must also
have Java Run Time Environment (JRE) installed with the “Use JRE X.Y.Z for <applet>” option enabled
under Tool --> Internet Options --> Advanced tab when using either Internet Explorer 6 or 7.
To launch the P-Series Node Manager:
Chapter 5 Web-based Management
Note: The web-based GUI is supported on Linux only, which is the default OS, and requires software
version 2.3.0.0 or newer.
Step Task
1
Enter the command pnic web-gui-start to enable the secure HTTP service on the P-Series (see
Appendix A , on page 79 ).
2
Lauch the P-Series Node Manager in a web brower by entering https://ipaddress in the address bar, as
shown in Figure 21 .
3
Login using the username and password configured on your P-Series appliance.