Global Technology Associates SOFTWARE FIREWALL GBWA200501-01 - Manual (Page 51)

4 – Troubleshooting 47
Appendix
Installing the Compact Flash Card
If you are installing your GB-Ware firewall on a Compact Flash card, use
these instructions to install the Compact Flash card for your firewall. The
instructions assume that the Compact Flash IDE adapter is being installed
in the intended firewall; modification is necessary to install the GB-Ware
firewall Compact Flash IDE adapter on an installation proxy computer.
Requirements
Required components include (clockwise from the left of the illustration):
• mounting posts
• Compact Flash IDE adapter board
• IDE cable
• 512 MB GTA-certified Compact Flash card
This component kit is available for purchase from GTA; GB-Ware may also
be installed to a hard drive instead of using a Compact Flash card kit.
Compact Flash IDE Adapter Components
Before beginning, do not plug in any part of the system; make sure that you
are properly grounded to prevent static electricity discharge before opening
the case.