GCC Printers 21 Series - Manual (Page 3)

FEDERAL COMMUNICATIONS COMMISSION
WARNING: This equipment was tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions in this manual, may
cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. For more information about radio frequency interference, refer to
the section of the Elite 21 User’s Manual on Radio and TV interference.
CANADIAN REGULATIONS
This equipment is a Class B digital apparatus that complies with the Radio Interference Regulations, CRC
c. 1374.
IMPORTANT: Changes or modifications to this product not authorized by GCC Technologies Inc. could
void the FCC Certification and negate your authority to operate the product. This product was tested for
FCC Compliance under conditions that included the use of shielded cables and connectors between system
components. It is important that you use shielded cables and connectors to reduce the possibility of
causing interference to radios, television sets, and other electronic devices. You can obtain the proper
shielded cables from GCC Technologies or from an Authorized GCC Technologies dealer.
CLASS 1 LASER PRODUCT
LASER SAFETY: This printer is certified as a Class 1 laser product under the U.S. Department of Health
and Human Services (DHHS) Radiation Performance Standard according to the Radiation Control for
Health and Safety Act of 1968. This means that the printer does not emit hazardous radiation. Since
radiation emitted inside the printer is completely confined within protective housings and external covers,
the laser beam cannot escape from the machine during any phase of user operation. The Center for
Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented regulations
for laser products on August 1, 1976. These regulations apply to laser products marketed in the United
States. The label on the printer indicates compliance with the CDRH regulations and must be attached to
the laser products marketed in the United States.
Caution - Use of controls, adjustments, or performance of procedures other than those specified
in this manual may result in hazardous radiation exposure
.
CREDITS
© Copyright GCC Technologies Inc., 2000. All rights reserved.
The Elite 21 Series Installation Guide was written by David Nicholson.
It was edited by Donna Atwood, Kevin Curran, Donald Damon, Lee Doron, Laurie Freitas,
Brian Harriss and Gregg Linzey.
Illustrations courtesy Xerox International Partners,Technical Services Group. Additional
illustrations by Adam DeFanti. Layout by Adam DeFanti and David Nicholson. Cover design
and layout by Adam DeFanti.
Installation Guide printed in USA. Part number 030-16478 Rev A.