GCC Printers 21 Series - Manual (Page 58)

55
Software Installation
The software required to set up your Windows NT 4.0 computer is
located on the Elite 21 Series CD-ROM.
Windows NT 4.0 uses a Wizard to help you install printer software. A
Wizard is a series of dialog boxes. In each dialog box you make configuration
choices then click the Next button to move to the next dialog box.
Part of the software you will need is contained on the Windows NT 4.0
CD-ROM. Please have this software available when doing the installation.
Note: These instructions cover installing the Elite 21 as a local printer
(connected via a parallel or serial port) on a Windows NT 4.0 workstation
or server.
If installing the printer as a stand-alone Ethernet device on a Windows NT
network, we recommend following these instructions as if the printer were
being installed as a local device on LPT1:. Once the installation is complete,
proceed to the Windows NT 4.0 section of Chapter 7 of the Elite 21
User’s Manual (Networking the Elite 21 Printer) on the printer CD-ROM for
instructions for setting up the printer as an Ethernet network device.
Installing the Elite 21 with Windows NT 4.0