GCC Printers 21 Series - Manual (Page 49)

46
Software Installation
The software required to set up your Windows 2000 computer is located
on the Elite 21 Series CD-ROM.
You can install the Elite 21 software on your computer using Plug and
Play. This will work if you are installing the software on a computer which
is connected to the printer through the parallel or USB port.
If the printer is not connected to the computer through the parallel or
USB port, go to the “Using Add Printer” section immediately following
Plug and Play instructions.
Windows 2000 uses a Wizard to help you install printer software. A
Wizard is a series of dialog boxes. In each dialog box you make
configuration choices then click the Next button to move to the next dialog
box.
Note: These instructions cover installing the Elite 21 as a local printer
(connected via a parallel or serial port) on a Windows 2000 workstation
or server.
If installing the printer as a stand-alone Ethernet device on a Windows
network, we recommend following these instructions as if the printer were
being installed as a local device on port LPT1:. Once the installation is
complete, proceed to the Windows 2000 section of Chapter 7 of the Elite
21 User’s Manual (Networking the Elite 21 Printer) on the printer CD-
ROM for instructions for setting up the printer as an Ethernet network
device.
Installing the Elite 21 with Windows 2000