GCC Printers 21 Series - Manual (Page 71)

68
Configuring Printer Drivers for use of the Additional Paper Feeder(s)
Once one or more additional feeders are installed, you will need to change settings within
the driver software on all the computers that use the printer. This will allow Tray 3
and/or Tray 4 to show up as options when selecting a paper source for your print jobs.
The drivers can be configured as follows:
Macintosh:
• Click once on the desktop printer icon for your printer to highlight it.
• Go to the Printing menu at the top of the screen, then down to “Change Setup...”
• In the Setup window, click on the “Change” pull-down menu and go down to “Additional
Trays.”
• Change the setting in the “To:” pull-down menu to either “Tray 3” (for one tray) or “Tray
3 and 4” (for two trays).
• Click OK to accept the change.
Windows 95/98:
• Go to the Start menu, then to Settings and Printers.
• Right-click the printer icon for your Elite 21 printer and select Properties.
• Click on the Device Options tab.
• Under Installable Options, click on “Additional Trays.”
• Under “Change Setting for:,” change the selection to either “Tray 3” (for one tray) or
“Tray 3 and 4” (for two trays).
• Click Apply and OK to accept the change.
Windows 2000:
• Go to the Start menu, then to Settings and Printers.
• Right-click the printer icon for your Elite 21 printer and select Properties.
• Click on the Device Settings tab, then scroll down to Installable Options.
• Click on the link next to Additional Trays that says “Not Installed.” This link will become a
pull-down menu.
• Change the selection to either “Tray 3” (for one tray) or “Tray 3 and 4” (for two trays).
• Click Apply and OK to accept the change.
Windows NT 4.0:
• Go to the Start menu, then to Settings and Printers.
• Right-click the printer icon for your Elite 21 printer and select Properties.
• Click on the Device Settings tab, then scroll down to Installable Options.
• Click on “Additional Trays” from the list of options.
• Under the “Change Setting to:” box, change the selection to either “Tray 3” (for one
tray) or “Tray 3 and 4” (for two trays).
• Click Apply and OK to accept the change.