GE Monogram ZV755 - Manual (Page 16)

16
Installation Instructions
INSTALLATION – RECIRCULATING
ASSEMBLE DEFLECTOR
AND CONNECTOR
A The duct connector is shipped
inside the deflector.
B Snap the plastic connector out
of the deflector and remove.
C Turn over the plastic
connector. From the bottom,
snap the connector over the
opening as shown.
4
INSTALL AIR DEFLECTOR ASSEMBLY
• Place the assembly
over the hood
outlet.
• Hold the assembly
against the ceiling.
The penciled
centerline should
show through
the slot on the
deflector. Mark
the two screw
holes on the back
of the assembly.
• Remove the
assembly and drill
1/8″ pilot holes into
the wall studs.
• Enlarge holes that did not enter studs to 3/8″ and
tap plastic or metal anchors into the holes, flush
with the wall.
• Mount the assembly onto the hood outlet, push
up against the ceiling and install the screws
provided.
• Use duct tape to seal the connection.
CAUTION:
Do not use sheet metal
screws at the hood duct flange connection. Doing
so will prevent proper damper operation. Seal
connections with tape only.
6
SIZE DUCT PIECE
• Hold air deflector
with duct
connector against
the ceiling. Align
window on the
back of the
deflector with the
marked centerline.
• Measure from
the bottom of
the deflector to
the top of the
hood as shown.
Reduce this dimension by
1″ to facilitate installation.
The duct will cover/overlap
the duct connector and the
exhaust outlet.
• Cut the duct piece to size
and slip onto the bottom of
the duct connector.
• Use duct tape to secure the
duct piece to the connector.
• Temporarily install the
2 small duct cover screws
into the sides of the deflector. Remove the screws.
This will ensure ease of final installation.
5
Centerline
Duct
length
Measure
length
Screws
Remove plastic connector
Snap into place
A
B
C
Air deflector assembly