Stovax E-Studio PR0776 - Manual (Page 23)

23
11. COMMISSIONING
11.1 Check all ceramics, doors etc.
11.2 Check flame picture
11.3 Check gas pressure
10. lIGhTING ThE APPlIANCE
10.1 • Locate the control valve on the fire. There are two
control knobs on the valve, the right-hand knob controls the
pilot ignition and the left hand knob controls the main
burner.
10.2 If your fire has already been upgraded to battery remote
control, please refer to the instructions provided with the
upgrade to operate the remote control. The
following instructions will work for either situation.
2
AR0914
• Ensure that the left-hand control knob is pointing to off (
).
• Ensure that the right hand control knob is pointing to
off ( ).
• Press in the right hand control knob and rotate it anti-
clockwise until a click is heard (keep pressing in) and the
knob is pointing to pilot . The pilot should now light. If
the pilot has not lit, repeat the procedure until it
does.
• Keep the control knob pressed for 10 seconds and then
release it, the pilot should stay alight. If the pilot goes out,
repeat the procedures until it does.
• Turn the right-hand control to point to main burner .
The fire can now be controlled using the left-hand
control knob.
• Turn the left hand control knob to point to low fire ,
the main burner will light on low. The burner can
now be controlled between low and high settings. Turn the
control knob anticlockwise increase the flame height and
clockwise to decrease the flame height.
ThE YEllOw FlAMES wIll APPEAR whEN ThE FIRE
hAS GAINED SUFFICIENT hEAT - TYPICAllY 10 TO 20
MINUTES.
INSTAllATION INSTRUCTIONS
INSTAllATION / COMMISSIONING