Stovax E-Studio PR0776 - Manual (Page 30)

30
19
AR1433
• Rotate the injector until it is fully removed
• Replace with the correct replacement injector. When
ordering, always state the model, gas type and serial
number.
• Reassemble and turn the gas supply on, check for any
leaks
12. ChANGING BETwEEN GAS TYPES
The following parts must be changed when converting an
appliance from one gas type to another:
E-BOX E-STUDIO
BURNER
ASSEMBLY
NG A8692 NG GZ6398
LPG AP8692 LPG GZ6960
DATABADGE PR0393EBF
Note: The control valve will be set for the particular appliance and
gas type. In all instances, when ordering new parts, be sure to
quote the appliance type and serial number.
Use only genuine Gazco replacement parts. Non-standard
components will invalidate the guarantee and may be
dangerous.
• Undo the two screws securing the valve to the bracket,
Diagram 17, Arrow E. The valve can now be removed.
17
AR1434
E
D C A
B
10. MAG UNIT
10.1 Undo the thermocouple nut, Diagram 18, Arrow A.
18
AR1434
A
• Undo the mag unit retaining nut at the back of the
control valve behind the thermocouple nut
After removing the retaining nut, the mag unit can be
tapped out and a replacement fitted.
• Replace the mag unit retaining nut and tighten. Note -
this is a gas-tight seal
• Replace the thermocouple and check for gas leaks
10.2 After reassembly, carry out the flame failure functional
check as detailed in the flow chart, especially the mag unit
drop out time.
11. MAIN INjECTOR
11.1 • Undo the two nuts securing the injector pipe, Diagram
19
SERvICING INSTRUCTIONS
REPlACING PARTS