Gyration GyroRemote and Mobile RF Keyboard - Manual (Page 10)

8
6. OPTIONAL: Press the LEARN button on the Receiver for 2 seconds
to exit “Learn Mode.” Otherwise, after five minutes, Learn Mode will
automatically time out.
If more than one device is being installed on the same system, place the
Receiver into Learn Mode (step 4 above) only once, then “Teach” each device
before exiting Learn Mode. Do not push the LEARN button on the receiver for
each device to be added. (See “Installing 3 or More Devices” on page 13.)
After the Teach/Learn sequence is performed, the receiver and the device
will remain synchronized after powering down and changing channels. It is
only necessary to perform the Teach/Learn sequence when setting a device
up for the first time or when adding additional devices to the system.
When the Receiver is put into Learn Mode, it erases its memory of previously
learned devices and looks for new devices. Therefore, when adding a new
device to a system it is necessary to put the Receiver into Learn Mode then
Teach all devices that will be used on the system.
To Determine Which Channel the Keyboard is Using
The Gyration Keyboard has eight individual channels available to it. To
determine which channel a device is currently using:
1. Press and quickly release the CHANNEL button on the keyboard.
Count the number of times the green LED light on the top of the
keyboard flashes. The number of flashes indicates the channel the
keyboard is using.
Note: If the keyboard’s channel is changed when the computer is powered down or the
receiver is not connected, the devices will become unsynchronized. When the system is
running, click and release the channel button as described above to initiate a “channel
confirm” operation. The keyboard broadcasts a message across all eight channels that
informs the receiver what channel it is currently operating on. The receiver then
automatically restores synchronization.