GE 25826GC - Manual (Page 28)

28
C
HARGE
/
IN USE
I
NDICATOR
When the charge/in use indicator on the base is lit, the handset is correctly
seated in the cradle and is charging. The indicator flashes, when the base
pages the handset, or when you receive an incoming call.
M
AKING A
C
ALL
1. Pick up the handset and press the talk/callback button. Listen for a
dial tone.
2. Dial the desired number, or pre-dial the number first then press the
talk/callback button.
3. When finished, press the talk/callback button again to hang up.
M
AKING A
C
ALL WITH THE
H
ANDSET
S
PEAKERPHONE
1. Press the spk button on the handset. You will hear a dial tone.
2. Dial a number. Or, pre-dial the number and then press the spk button.
3. When finished, press the talk/callback button to hang up.
NOTE: You can enter up to 32 pre-dial digits. If you want to delete the
pre-dial number you entered, press the delete/redial button until all of
the digits are erased.
NOTE: The unit only supports tone dialing mode.
A
NSWERING A
C
ALL WITH THE
H
ANDSET
1. When the phone rings, press the talk/callback button on the handset.
2. When finished, press the talk/callback button again to hang up.
A
NSWERING A
C
ALL WITH THE
H
ANDSET
S
PEAKERPHONE
1. When the phone rings, press the spk button to answer a call.
2. When finished press talk/callback to hang up.
NOTE: If you are using the handset and want to switch to the handset
speakerphone, press spk button once. Pressing the spk button a second time
will turn the handset speaker phone off and back to the earpiece. At any time
during a conversion, if talk/callback button is pressed, the line will be
dropped and end the call.