GE JCB968 - Manual (Page 16)

Consumer Support
Tr
oubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Make sure the clock is set to the
correct time of day.
The Kitchen Timer is a minute timer only.
The Kitchen Timer does not control
oven operations. The maximum
setting on the Kitchen Timer is 9 hours
and 59 minutes.
16
Using the clock, kitchen timer and control lockout.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle. Touch the CLOCK pad.
Touch the number pads.
Touch the START pad.
To Set the Kitchen Timer
Touch the KITCHEN TIMER
ON/OFF pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a
mistake touch the KITCHEN TIMER
ON/OFF pad and begin again.
Touch the START pad.
After touching the START pad, SET disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the Kitchen Timer reaches :00,
the control will beep 3 times followed
by one beep every 6 seconds until
the KITCHEN TIMER ON/OFF pad is
touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
To Reset the Kitchen Timer
If the display is still showing the time
remaining, you may change it by
touching the KITCHEN TIMER ON/OFF pad,
then touch the number pads until the
time you want appears in the display. If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time by
touching the KITCHEN TIMER ON/OFF pad
and then touching the number pads to
enter the new time you want.
To Cancel the Kitchen Timer
Touch the KITCHEN TIMER ON/OFF
pad twice.
Oven Lockout
Your control will allow you to lock out the touch
pads so they cannot be activated when pressed.
To lock/unlock the touch pad controls:
Touch the OVEN LOCKOUT pad,
then touch the START pad.
The oven display will show Loc On
for several seconds, then they will
go blank until a cooking pad is
touched.
To unlock the control, touch the
OVEN LOCKOUT pad, then touch the
START pad.
If the range control is locked and a
cooking pad is touched, the oven display
will show that the control is locked.
■ The knob-controlled surface units will still
be active.