GE JCB968 - Manual (Page 38)

REPLACE THE STORAGE
DRAWER
Place the drawer rail on the guides.
Push the drawer in until it stops.
Lift the front of the drawer and push in
until the stops clear the guides.
Lower the front of the drawer and push in
until it closes. D
C
B
A
5 REMOVE STORAGE DRAWER
Pull the drawer out until it stops.
Lift the front of the drawer until the
stops clear the guide.
Remove the drawer. C
B
A
3
ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the Safety
Instructions and the instructions that fit your
situation before beginning installation.
WARNING —
• Range must be secured by Anti-Tip bracket
supplied.
• If the Anti-Tip device supplied with the
range does not fit this application, use the
universal Anti-Tip device WB2X7909.
• See instructions to install (supplied with
bracket).
• Unless properly installed, the range could
be tipped by stepping or sitting on the door.
Injury may result from spilled hot liquids
or from the range itself.
2
38
Installation Instructions
INSTALL THE RANGE
Stop
Typical installation of anti-tip bracket attachment to wall
Bracket
Screw must
enter wood
or metal
Wall plate
LEVEL THE RANGE
Install the oven shelves in the oven
and position the range where it will be
installed.
Check for levelness by
placing a spirit level or
a cup, partially filled
with water, on one of
the oven shelves. If
using a spirit level, take
two readings—with the
level placed diagonally first in
one direction and then the other.
The front leveling legs can be adjusted
from the bottom and the rear legs can be
adjusted from the top or the bottom.
Use an open-end or adjustable wrench
to adjust the leveling legs until the range
is level. D
C
B
A
4
Leg
leveler
Lower
range
Raise
range
Spirit level
Stop