GE JCB968 - Manual (Page 33)

33
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Roasting rack
Offset racks
Oven rack
Wipe up heavy soil on the oven
bottom.
www.GEAppliances.ca
Oven Floor
Do not clean the broil element. Any soil
will burn off when the element is heated.
Clean the oven floor with warm, soapy
water. On some models, the bake element is not
exposed and is under the oven floor. If spillovers,
residue or ash accumulate on the oven floor,
wipe up before self-cleaning.
The convection roasting rack should be
removed from the oven before beginning
the self-clean cycle. Clean with an abrasive
cleanser or steel wool. After cleaning,
rinse the rack with clean water and
dry with a clean cloth.
If your oven is equipped with shiny,
silver-colored oven racks, they should be
removed from the oven before beginning
the self-clean cycle. Clean with an abrasive
cleanser or steel wool. After cleaning,
rinse the racks with clean water and dry
with a clean cloth.
If your oven is equipped with gray
porcelain-coated oven racks, they
may be cleaned in the oven during
the self-clean cycle.
NOTE: The shiny, silver-colored oven racks (on
some models) and the convection roasting rack
may be cleaned in the self-cleaning oven.
However, the racks will darken in color, lose their
luster and become hard to slide if cleaned during
the self-cleaning cycle.
To make the racks slide more easily,
apply a small amount of vegetable oil
to a paper towel and wipe the edges
of the oven racks with the paper towel.
Do not spray with Pam
® or other
lubricant sprays.
Oven Racks and Convection Roasting Rack
Painted surfaces include the door,
top of the control panel and the drawer
front. Clean these with soap and water or
a vinegar and water solution. Do not use commercial oven cleaners,
cleaning powders, steel wool or harsh
abrasives on any painted surface.
Painted Surfaces
Do not use a steel-wool pad; it will scratch
the surface.
Shake bottle well.
Place a small amount of Stainless
Steel Appliance Cleaner on a damp
cloth or damp paper towel.
Clean a small area (approximately
8
″ x 8″), rubbing with the grain of
the stainless steel if applicable.
Dry and buff with a clean, dry paper
towel or soft cloth.
Repeat as necessary.
To inquire about purchasing Stainless
Steel Appliance Cleaner, or to find the
location of a dealer or Camco Parts Store
nearest you, please call our toll-free
number:
National Parts Center 1-800-661-1616
www.GEAppliances.ca
Stainless Steel Surfaces (on some models)