GE JCB968 - Manual (Page 8)

8
Consumer Support
Tr
oubleshooting T
ips
Care and Cleaning
Operating Instructions
Safety Instructions
Be sure you turn the control knob to
OFF when you finish cooking.
Using the surface units.
Dual Surface Unit Control Knob (on some models)
The right front surface unit has 2 cooking sizes
to select from so you can match the size of the
unit to the size of the cookware you are using.
To use the small (6
″) surface unit, turn
the control knob to the SMALL BURNER
settings.
To use the large (9
″) surface unit, turn
the control knob to the LARGE BURNER
settings.
How to Set
Push the knob in and turn in either
direction to the setting you want.
At both OFF and HI the control clicks
into position. You may hear slight clicking
sounds during cooking, indicating the
control is keeping the power level you set.
A HOT SURFACE indicator light, on
the cooktop, will glow when any radiant
element is turned on. It will remain
on until the surface is cooled to
approximately 150°F.
Hot surface indicator light will:
■
come on when the unit is hot to the touch.
■
stay on even after the unit is turned off.
■ glow until the unit is cooled to approximately 150°F.
WARNING:
The surface
units are automatically disabled during
the self-clean cycle. Make sure that all
surface unit controls are turned off at all
times during the self-clean cycle. Any
surface unit that is set to an on position,
while the self-clean cycle is operating, will
automatically come on after the self-clean
cycle is finished, and could result in an
on, unattended surface unit. Wait until
the self-clean cycle is finished to set and
use the surface units.
Using the Bridge Burner (on some models)
To use the bridge burner, turn the
left front control knob to the BRIDGE
BURNER settings.
For full bridge surface unit operation,
also turn on the left rear surface unit.
To use only the front surface unit, turn
the control knob to the FRONT BURNER
settings.