GoVideo GV8050 - Manual (Page 9)

RECEIVING CABLE AND TV SIGNALS 9
Once you have your 8mm/VHS Dual-Deck VCR hooked up to
your antenna or cable system, you’ll need to set the antenna
and the channel memory:
1. Press
MENU
on your remote control until the SETUP
MENU appears on your screen. You may have to press
MENU more than once.
2. Press
SELECT
to choose the TUNER/CHANNEL MENU.
3. Set the ANTENNA IN. Press
SELECT
repeatedly to cycle
through these choices: TV, STD CATV, HRC CATV, IRC
CATV. If you don’t subscribe to cable television, select
TV. If you subscribe to cable television, you will most
likely select STD CATV. Call your cable company if you
are uncertain about which setting to use.
4. Using the TRK/MENU ▼ and ▲ keys or the numerical
keys, move to the AUTO PROGRAM item. Press
SELECT
to begin automatic channel programming. The VCR will
go through all the possible TV and cable channels, and
will automatically put the channels which you receive
into Channel Memory. This will take a few minutes to
complete.
5. If you wish, you can program certain channels into or out
of Channel Memory manually. To do this, see the
TUNER/CHANNEL MENU section of the Setup Menu
chapter in the Reference Guide.
6. Press
QUIT
to save these changes and to exit the menu
system.
2: AUTO PROGRAM
TUNER/CHANNEL MENU
1: ANTENNA IN
MENU KEY FOR PREV MENU
SELECT KEY TO CHOOSE
ARROW KEYS TO CHANGE
4: TUNER AUDIO
-
-
STD CATV
3: SET CHANNEL MEMORY
STEREO
Setting the Antenna
and Channel Memory
Unless you have a cable converter box, you can now use
the remote control to change channels. If you have a
cable converter box, you must keep your 8mm/VHS Dual-
Deck VCR tuned to the channel that your cable company
uses (call your cable company for this information), and
you must use the cable converter box to change channels.