GE DS-82 - Manual (Page 156)

Chapter 6: Command Line Interface
152 GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual
21 | off | 1
22 | off | 1
25 | off | 1
26 | off | 1
Trk1 | off | 1
Trunk Configuration
Trunk allows the switch to combine ports so that they function like a single high-
speed link. It can be used to increase the bandwidth to some devices to provide a
high-speed link. For example, trunk is useful when making connections between
switches or connecting servers to the switch. Trunk can also provide a redundant link
for fault tolerance. If one link in the trunk failed, the switch can balance the traffic
among the remaining links.
NOTE: The 10/100 Mbps port cannot be trunked with gigabit port (port 25-26).
All ports in the same trunk group will be treated as a single port. If a trunk group
exists, the ports belonging to that trunk will be replaced by "TRUNK #" in the VLAN
configuration screen. The following example configures port 25-26 as "TRUNK 1."
Trunking Commands
show trunks
Description:
Show trunking information.
Switch(config)# show trunk
Group ID | LACP | Ports | LACP Active
--------------+--------+-------------------+-----------------
1 | Yes | 23,24 | 23,24