GE DS-82 - Manual (Page 16)

Chapter 2: Installation
12 GE-DS-82 and 82-PoE Ethernet Managed Switch User Manual
Gigabit TP Interface
Port-9, Port-10: 10/100/1000Base-T Copper, RJ-45 Twist-Pair: Up to 100 meters.
Gigabit SFP Slots
Port-9, Port-10: 1000Base-SX/LX mini-GBIC slot, SFP (Small Factor Pluggable)
transceiver module: From 550 meters (Multi-mode fiber), up to 10/30/50/70/120
kilometers (Single-mode fiber).
Reset button
At the left of front panel, the Reset button is designed to reboot the Managed Switch
without turning the power off. The following table summarizes the Reset button
functions:
Reset Button Pressed and Released Function
About 1-3 seconds Reboots the Managed Switch
Until the PWR LED goes out
Resets the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
• Default Password: admin
• Default IP address: 192.168.0.100
• Subnet mask: 255.255.255.0
• Default Gateway: 192.168.0.254
LED Indications
The front panel LEDs provide instant status of port links, data activity and system
power. They help monitor the system and aid in troubleshooting when necessary.
The front panel LEDs are shown in Figure 2.
Figure 2: GE-DS-82 LED panel