GE JV965 - Manual (Page 11)

Installation Instructions
11
TOOLS AND MATERIALS
REQUIRED
(NOT SUPPLIED)
Pencil and
tape measure
Spirit level
Phillips and
Flat blade screwdrivers
Duct tape
Electric drill with
1/8 ″ and 3/8″ bits
1/4
″ pivoting hex socket
Safety glasses
Flashlight
Saber saw or Key Hole Saw
Metal Snips
Hammer
Pliers
Additional Materials:
• 120V 60Hz. 15 or 20 Amp, 2 wire with ground.
Properly grounded branch circuit.
• Strain relief for junction box.
• 7
″ round metal duct or 3-1/4″ x 12″ rectangular duct,
length to suit installation.
Wire Cutter/
Stripper
Ladder
Allen
Wrench
CAUTION:
Lift hood by grasping the outside
edges of the exhaust opening on the top. Do not
lift hood by the exhaust opening divider – damage
will occur!
REMOVE THE PACKAGING
• Remove parts package from the “V” shaped cardboard
insert. Remove insert. Remove shipping pads.
• Lift the hood out of the box.
• Remove transition duct piece from the inside of the
hood. Discard screws.
• The vent hood motor is shipped secured to the skid
with 4 screws. Locate and remove 2 screws on each
side of the motor. Discard the shipping skid.
• From the inside of the hood, remove shipping screws
holding the wood mounting piece to the back side of
the hood. Set aside wood mounting piece and screws
for later installation. Do not discard.
• Remove junction box cover and knockout.
• Install strain relief onto back or top of hood.
• Remove all tape and packing material from the
hood, duct transition and motor.
Hold Down Screws
Hold Down Screws
UL Listed Wire nuts
Hood
Parts
Package
Wood
Mounting
Support
Duct
Transition
Motor
Mounted
on Skid
Shipping Carton