Maytag W10445417B - Manual (Page 17)

17
1.
Prepare your 3-wire cable
for direct connection
1"
(25 mm)
3½"
(89 mm)
2.
Remove center screw
B
Use where local codes permit connecting cabinet-ground
conductor to neutral wire.
Remove center terminal block screw (B).
Direct wire cable must have 5 ft. (1.52 m) of extra length so
dryer may be moved if needed.
Strip 3
1 /
2
" (89 mm) of outer covering from end of cable. Strip
insulation back 1" (25 mm). If using 3-wire cable with ground
wire, cut bare wire even with outer covering. Shape wire ends
into hooks.
3.
Connect neutral wire
D
B
Place hooked end of neutral wire (white
or center) (D) of direct wire cable under
center terminal block screw (B), hook
facing right. Squeeze hooked end together.
Tighten screw.
3-Wire Direct Wire Connection
4.
Connect remaining wires
Place hooked ends of remaining direct wire cable wires under
outer terminal block screws (hooks facing right). Squeeze hooked
ends together and tighten screws. Replace the terminal block
cover on the back of the dryer. Tighten strain relief nut. Now,
go to“ Venting Requirements.”