Maytag W10445417B - Manual (Page 19)

19
Plan Vent System
Choose your exhaust installation type
Recommended exhaust installation:
Vent System Chart
Number of
90° elbows
Type
of vent
Box/louvered
hoods
Angled
hoods
1
2
0 Rigid metal
Rigid metal
Rigid metal
90 ft. (27.4 m)
80 ft. (24.4 m)
70 ft. (21.3 m)
80 ft. (24.4 m)
70 ft. (21.3 m)
60 ft. (18.3 m)
The “Vent System Chart” provides venting requirements that will
help achieve best drying performance.
Special provisions for mobile homes:
Exhaust vent must be securely fastened to a noncombustible
portion of mobile home and must not terminate beneath the
mobile home. Terminate exhaust vent outside.
Determine vent path:
n Select route that will provide straightest and most direct
path outdoors.
n Plan installation to use fewest number of elbows and turns.
n When using elbows or making turns, allow as much room
as possible.
n Bend vent gradually to avoid kinking.
n Use as few 90° turns as possible.
Determine vent length and elbows needed for best
drying performance:
Use the following “Vent System Chart” to determine type of vent
material and hood combinations acceptable to use.
NOTE: Do not use vent runs longer than those specified
in “Vent System Chart.”
Exhaust systems longer than those specified will:
n Shorten life of dryer.
n Reduce performance, resulting in longer drying times
and increased energy usage.
A. Dryer
B. Elbow
C. Wall
D. Exhaust hood
E. Clamps F. Rigid metal or
flexible metal vent
G. Vent length necessary
to connect elbows
H. Exhaust outlet
A B C
D
E
F
B
G
H
Alternate installations for close clearances:
Venting systems come in many varieties. Select the type best
for your installation. A close-clearance installation is shown
below. Refer to the manufacturer’s instructions.
Over-the-top installation (also available with one offset elbow)
Over-the-Top Installation Kit Part Number 4396028 for close
clearance alternate installation is available for purchase.
For ordering information, see “Assistance or Service.”