Motorola ME4066 Series - Manual (Page 6)

9
10
In
st
al
la
ti
o
n
In
st
al
la
ti
o
n
Do not expose the base station and charger unit to direct sunlight. Do
not allow the base station and charger unit to become wet. They should
not be set up in rooms which are subject to condensation or corrosive
steam or a high concentration of dust (e.g. cellars, garages or
conservatories). The room temperature must be between 0
0 C and 35 0 C.
Connecting the Base Station and Mains Adaptor
Insert the plug of the mains adaptor in the socket on the underneath
of the charger unit. Plug the mains adaptor into the mains socket.
The charger unit is now ready to use.
Connecting the Charger Unit
Open the battery compartment by pushing downwards on the
battery compartment cover. Insert the 2 x AAA batteries supplied,
observing the correct polarity.
Inserting the Batteries
The mobile handset will not operate if the batteries are
inserted incorrectly. There is also a possibility that
the handset may be damaged.
Replace the cover on the battery compartment and push it upwards
until it clicks into place. Place the handset on the base station.
You will hear a beep and the charging light comes on.
Note: When used for the first time, allow the batteries to charge for at least 14 hours
without interruption. If possible, only take the handset out of the base station when
the charging process has ended. This will help to guarantee optimum operation.
Note: To ensure the battery charges properly, clean the charging contacts on the handset
and charger with a soft, dry cloth once a month. Clean more often if the unit is subject to
grease, dust or high humidity.
1. Plug the telephone line cord into the base station socket.
2. Route the cord underneath the base station towards the back.
3. Plug the other end into the telephone wall socket.
4. Connect the mains power supply.
The base station does not have a power
switch. Only use the mains adaptor supplied
with your phone.
Attaching the Belt Clip
Push the belt clip into the opening on the back of the handset.
The clip will bend slightly until it clicks into place.